W&T Com-Server++, Manual

Page: 51 / 228

51
W&T
Configuration access to the Com-Server
Subject to error and alteration
After finishing your entry by pressing the Return key, the
values are stored in the non-volatile memory and you can im-
mediately access the Com-Server and the set WBM port using
your Internet browser.
1
Additional information about serial configuration
possibilities for the Com-Server can be found in the sec-
tions Assigning the IP Address .
Example 1:
Here the IP address
172.17.231.99 is assigned to the Com-
Server and +w80 is used to activate the WBM on the HTTP
standard port.
xxx... -> Com-Server
IP no.+<ENTER>: <- Com-Server
172.17.231.99 +w80 -> Com-Server
172.17.231.99 -1 <- Com-Server
Example 2:
In this example the Com-Server gets an IP address, subnet
mask and gateway. In addition
+w8585 is entered to activate
WBM on TCP port 8585.
xxx... -> Com-Server
IP no.+<ENTER>: <- Com-Server
172.17.231.99,255.255.0.0,172.17.231.1 +w8585 -> Com-Server
172.17.231.99 ,255.255.0.0,172.17.231.1+w8585 <- Com-Server
7�3�3 Activating WBM from the configuration menu
If you want to activate WBM on an already operational Com-
Server, you can do this via Telnet configuration. Start a Telnet
session on port 1111 of the Com-Server. In the menu branch
SETUP System
r
Setup TCP/IP
r
System Port List
r
WBM Port
enter the decimal number of the desired TCP port under
which you want to reach the WBM. Then press the Return key
until you are back in the main menu and from there open the