Lyla | Instructions for Use | RIN-210 ENG Rev02 | 15/09/2022 | © W&H Sterilization Srl
31
Getting started
SET THE DISPLAY BRIGHTNESS
To change the display brightness:
1
On the homepage, tap
>
>
>
2
Tap
or
to change the value.
3
Tap
to confirm and go back to the previous page.
CONNECT TO A NETWORK
If you connect through an Ethernet cable, in most cases the sterilizer
will connect to the network automatically. If it does not connect
automatically, or if you are using a Wi-Fi dongle key, follow the
following procedure under supervision of your IT manager / network
administrator.
1
On the homepage, tap
>
>
.
2
If the connection is through the Ethernet cable, tap
: the
TCP/IP screen appears.
3
If the connection is through Wi-Fi key, tap
: after a while, the
sterilizer shows the available networks found. Choose the
network, enter the credentials in the further screen, then tap
to confirm: the TCP/IP screen appears.
Note
: the
and
icons are disabled if the connectivity
means (cable or Wi-Fi key) are not properly plugged.
Note
: in the TPC/IP screen, the
icon is visible only if you
make any change. The Wi-Fi icon at the bottom isn't visible if
you connect through Ethernet cable.
4
If your network supports dynamic IP addresses (ask your
IT manager), enable the options
Dynamic
both in
IP
Configuration
and in the
DNS Configuration
fields, then tap
to confirm: all entry fields are disabled.
5
If your network does not support dynamic IP addresses (ask
your IT manager), enable the options
Static
both in
IP
Configuration
and in the
DNS Configuration
fields. Tap on each
entry field and enter the IP addresses (ask your IT manager for
details). Then tap
to confirm.
User authentication (optional)
FUNCTION AVAILABILITY
To access the user management functions the
User Management
activation code must be entered. The activation code is required only
at the first access to the
User Management
(
) or the
Options
(
) menus: after the code was entered, the function is enabled and
there is no need to enter the code again.
To acquire the activation code please refer to the Activation code
instructions.
