Wamsler Club edition, User Instruction

Page: 30 / 96

30
Open the door by raising the handle (Picture 2a). If the equipment is hot, you can
use insulated gloves. Adjust the primary air regulator (Picture 3) according to the
Table 2. Put coal lighter or wood wool onto the fire grate, followed by wood chips.
First insert small pieces of wood, and then larger ones, light them and close the
door again. When the wood burns quickly, and leaves sufficient glowing embers,
put additional fuel on the fire. Thereafter, adjust the primary air regulator according
to the Table 2 („Adjustment of the burning air”). The first kindling should be per-
formed “finely” with little fuel only, so that the parts of the fireplace be adapted to
heat. During the first kindling, the generation of smell is normal and absolutely un-
dangerous.
1.3 Putting out of operation
•
Let the glowing ember burn to ashes and the fire-place get cold.
•
Empty the furnace chamber and the ash bin.
•
Close the doors, and shut off the primary air regulator (Table 2)
1.4 Heating instructions
The fireplace should be operated only with closed furnace chamber door. Fire-
places belonging to type 1 have self-locking furnace chamber doors. These doors
may be opened only for kindling, loading or when cleaning the furnace chamber
(otherwise draught problems may occur with other equipment connected to the
same chimney).
Warning! When opening the furnace chamber door, any incorrect handling or
insufficient draught may induce smoke. Always ensure that the furnace
chamber door may be opened only slowly, first just to a small extent, and
then fully after a few seconds. In addition, if you intend to put additional fuel
into the fire, before the opening of the door only there may be only ember bed
in the burning space, i.e. no flames may be visible.
Led into the burning space
in correspondence with the existing conditions, the secondary air provides for the
follow-up burning of the combustible components of in the burning space. This in
fact means smoke and soot-poor burning, which contributes to the protection of the
environment. If you wish to commission the fireplace in a transitional period,
please, please first examine the chimney draught, as it can be especially weak at
high external temperatures. Towards this end, hold a burning match in the slightly
opened feeding door. If the flame is not drawn significantly by the draught, then a
so-called starting fire is to be set first. Towards this end, burn wood chips/wool in
the fireplace or the cleaning hole of the chimney. The fire grate is to be cleaned
before every kindling to ensure the proper inflow of air for burning. The ashtray is to
be emptied regularly (Figure 4). Should the equipment be extremely hot, use the
gloves provided. Please, be careful not to dispose glowing materials into the waste
bin.
Ensure that the ashtray should be fully pushed into the equipment.
Warning! In order to keep the air clean and safeguard the fireplace, do not
exceed the specified maximum fuel quantity, otherwise overheating may oc-
cur, which potentially damage the equipment. Such damage is not covered