WXR720/L, WXR740/L
Trailer Wood Splitter
Service and Maintenance
37
8.9 Troubleshooting
The following table lists some problems that may be
encountered, with possible causes and solutions.
If a problem persists after reading through the Troubleshooting
section, contact the local dealer, distributor or Wallenstein
Equipment. Have the machine serial number ready.
Engine related issues
Refer to the Honda™ GX200 owner's manual found in the
manual tube.
Problem
Cause
Solution
Cylinder rod moves slowly or does not move.
Screeching or hissing noise.
No hydraulic oil pressure.
Oil filter plugged. Change filter.
Low hydraulic oil level. Add oil.
System relief pressure setting too low. Call technician.
Wood jammed around wedge.
Shut machine off and safely remove wood.
Low engine speed.
Check throttle is set to maximum. Check that choke is
off.
Control handle does not go to neutral after rod
is fully retracted.
Valve detent set too tight.
Adjustment required to detent on valve.
Hydraulic oil too cold.
Allow machine to warm up.
Hydraulic fluid is contaminated.
Change hydraulic fluid and filter.
Control handle goes to neutral before rod is
fully retracted.
Detent set too loose.
Adjustment required to detent on valve.
Control handle does not go to neutral when
released.
Control may be damaged.
Control may need service or be replaced. Call
technician.
Cylinder stops on contact with wood.
Second stage on pump not functioning.
Pump may need to be serviced or replaced. Call
technician.
Wedge or push block jumps.
Wedge or push block frame jamming.
Lubricate slider wear plates.
Leaking hydraulic hose.
Hose worn or damaged.
Replace hose.
Leaking cylinder.
Seals worn.
Seal replacement may be required. Call technician.
Summary of Contents for WXR720
Page 44: ...www wallensteinequipment com...
