Safety Signs
WXR720/L, WXR740/L
Trailer Wood Splitter
Safety
14
3.2 Replacing Damaged Safety
Signs
•
Always replace safety signs that are missing or have
become illegible. Replacement safety signs are available
from your authorized distributor, dealer parts department,
or the factory.
•
Keep safety signs clean and legible at all times.
•
Parts replaced that had a safety decal on them must also
have the safety sign replaced.
Procedure
Installation area must be clean and dry. Make sure the surface is
free of grease or oil. Ambient temperature must be above 50 °F
(10 °C).
NOTE: Determine exact position before removing the
backing paper on the decal.
1.
Peel the decal off the backing sheet.
2.
Align the decal with an edge on the machine if possible.
3.
Starting on one edge, carefully press the center of the
exposed sticky backing in place, smoothing it out as you
work from one side to the other.
4.
Use a squeegee, credit card or similar to smooth it out.
Work from one end of the decal to the other end.
Small air pockets can be pierced with a pin and smoothed out
using the piece of sign backing paper.
Summary of Contents for WXR720
Page 44: ...www wallensteinequipment com...
