7.
Close the draw latch over the catch on the adapter. This
secures the chain saw to the holder.
01139
Fig. 29 –
Holder draw latch
8.
Rotate the holder and move the chain saw through the full
range of motion. Make adjustments to the pivot base, as
required (based on the saw length).
9.
Check the chain saw range of motion. Make sure the
chain-saw bar cannot contact any part of the machine. If
required, remove the chain saw from the holder and adjust
the adapter position.
WP845 / WP875
Trailer Firewood Processor
Operating Instructions
39