6. Operating Instructions
Read and understand the operating instructions before using the
machine.
6.1 Operating Safety
WARNING!
Wear the personal protective equipment (PPE)
that is required to complete the work safely.
For example; a hard hat, hearing protection,
protective eye wear, protective footwear,
respirator, and gloves.
W101
CAUTION!
Park the machine so prevailing winds blow
exhaust gases / fumes away from the operator.
W006
The operator is responsible to be familiar with and follow all
operating and safety procedures.
Read and understand all the
safety information in this manual before operating the firewood
processor.
•
Read the chain saw and engine manufacturer's manuals
and follow all safety instructions.
•
Park the machine in a clear location on dry, level ground.
Do not operate the machine on a hillside or area that is
cluttered, wet, muddy, or icy to prevent slips and trips.
•
Keep the work area clean and free of debris.
•
Never operate an engine inside a closed building. The
exhaust fumes may cause asphyxiation.
•
De-limb logs before loading them.
•
Do not try to process more than one log at a time. The extra
log can move unexpectedly and cause injury.
•
Never reach into the splitting area with your hands while
the machine is operating. Use a hookaroon or peavey to
reposition cut logs in the splitting area.
•
Do not try to split logs across the grain. Logs can burst or
splinter, and then fly out of the machine causing injury.
•
Use care when pulling logs from a pile. The logs can roll
when attaching a rope or during winching. Use a hookaroon
or peavey to handle logs for positioning.
•
Do not move or transport the machine with the engine
running.
•
Never stand, sit, or climb on any part of the machine while
the engine is running.
• Never operate the machine alone!
Always have at least
two fully trained people present:
-
It is recommended that there be one operator and one
spotter present during machine operation. Both the
operator and spotter must be completely familiar with all
the machine safety, controls, and operating functions.
-
The operator must be in control of the machine at all
times. The spotter must remain outside of the hazard
zone, while the machine is in operation.
•
Keep bystanders at least 10 ft (3 m) from the stacking
zone. Mark the safe zone with safety cones.
•
Before starting the machine, close and secure all guards,
shields, deflectors, and covers. If a guard, shield, or cover
is removed, replace it.
•
Turn off the engine before leaving the machine unattended.
WP845 / WP875
Trailer Firewood Processor
Operating Instructions
25