Wallenstein WP845, Operator'S Manual, Page: 18 / 72

4. Familiarization
A Wallenstein 800 Series firewood processor is designed to
process logs into split firewood. Winch a log up the lead-in
chute, through the log-loader chute, to the log-length guide. Use
a chain saw to cut the log to the required length. The cut log
rolls into the splitting cradle. Activate the push block to move
it forward and split the log. The split log pushes previously
split logs up the splitter chute and out of the machine. Power
to operate the machine is provided by the gas engine and the
hydraulic pump.
4.1 New Operator
WARNING!
Make sure all operators understand how to
place the machine in a safe condition before
performing any service, maintenance, or storage
preparation. For instructions, see Safe Condition
on page 9 .
It is the responsibility of the owner and the operator to read
this manual, and to train all other operators before they work
with the machine. Follow all safety instructions.
Untrained operators are not qualified to use the machine.
They can endanger themselves and others or damage property.
4.2 Training
Each operator must be trained in the correct operating
procedures before using the machine. The
Sign-Off Form on
page 10 can be used to keep a training record.
1. Review control locations, functions, and movement
directions.
2. Move the machine to a large open area and allow the new
operator to become familiar with control functions and
machine responses.
3. When the new operator is familiar and comfortable with the
machine, they can proceed with the work.
4.3 Work Site Familiarization
It is the responsibility of the operator to be thoroughly familiar
with the work site before starting work. Avoid unsafe situations
and make every effort to prevent accidents.
For more information, see Create a Safe Work Area on page
11 .
When you set up a work site, consider the following things:
• Avoid close or cramped workspaces. Make sure there is
enough space and clearance for the machine and winching.
• Position the machine so prevailing winds blow engine
exhaust fumes away from operator's location.
• Choose flat, level ground, and make sure the machine is
level before operating it.
• Avoid muddy or soft ground where the jack stand and
supports will sink. If soft ground is unavoidable, place
boards or plates under the jack stand and supports to
increase the surface area.
4.4 Operator Orientation
IMPORTANT! When describing controls throughout this
manual, the directions for left hand (LH), right hand (RH),
backward, and forward are determined when standing at the
operator controls facing the direction of forward machine
travel.
Fig. 5 –
Direction of forward machine travel
Familiarization
WP845 / WP875
Trailer Firewood Processor
18