14. Warning!
Risk of cancer and
reproductive harm
The machine materials
contain chemicals or
machine operation may
produce gases or dust that
are identified by the state
of California as causes of
cancer, birth defects, or
other reproductive harm.
This warning is required by
the state of California, USA
to comply with Proposition
65: the Safe Drinking Water
and Toxic Enforcement Act
of 1986.
3.3 Replace Damaged or Missing
Safety Signs
•
Always replace safety signs that are missing or have
become illegible. Replacement safety signs are available
from your authorized distributor, dealer parts department,
or Wallenstein Equipment.
•
Keep the safety signs clean and legible at all times.
•
Parts replaced that had a safety sign (decal) on them must
also have the safety sign replaced.
Requirements
•
The installation area must be clean and dry.
•
The application surface must be clean and free of grease
or oil.
•
The ambient temperature must be above 50 °F (10 °C).
•
A squeegee, plastic bank card, or similar tool is required to
smooth out the decal.
Procedure
Determine the exact position for the decal before
removing the backing paper. If possible, align the
decal with an edge on the machine.
1.
Peel the decal off the backing paper.
2.
Position the decal above the location where it is being
applied to the machine.
3.
Starting at one edge, carefully press the center of the
exposed sticky-backing in place, smoothing it out as you
work from one side to the other.
4.
Use an appropriate tool to smooth out the decal, working
from one end to the other.
Small air pockets can be pierced with a pin and smoothed
out using a piece of the decal backing paper.
WP845 / WP875
Trailer Firewood Processor
Safety Signs
17
