Wallenstein MX130P, Operator'S Manual

Page: 14 / 44

9. WARNING!
Do not operate machine without shields
in place.
Failure to do so may cause serious injury
or death.
2.10 Replacing Damaged Safety Signs
IMPORTANT! If parts are replaced that have safety signs
on them, new signs must be applied. Safety signs must
always be replaced if they become damaged, are removed,
or become illegible.
• Always replace safety signs that are missing or have
become illegible. Replacement safety signs are available
from your authorized distributor, dealer parts department,
or Wallenstein Equipment.
• Keep the safety signs clean and legible at all times.
• Parts replaced that had a safety sign (decal) on them must
also have the safety sign replaced.
Requirements
• The installation area must be clean and dry.
• The application surface must be clean and free of grease
or oil.
• The ambient temperature must be above 50 °F (10 °C).
• A squeegee, plastic bank card, or similar tool is required to
smooth out the decal.
Procedure
NOTE: Determine the exact position for the decal before
removing the backing paper. If possible, align the
decal with an edge on the machine.
1. Peel the decal off the backing paper.
2. Position the decal above the location where it is being
applied to the machine.
3. Starting at one edge, carefully press the center of the
exposed sticky-backing in place, smoothing it out as you
work from one side to the other.
4. Use an appropriate tool to smooth out the decal, working
from one end to the other.
Small air pockets can be pierced with a pin and smoothed
out using a piece of the decal backing paper.
Safety
MX130P
Manure Spreader
Safety
14