Wallenstein FX40, Operator'S Manual

Page: 34 / 48

8.8 Clutch Brake Pads – Changing
To change or repair the clutch pads, remove the clutch/
drum frame assembly from the winch.
IMPORTANT! Leave winch attached to tractor for
support.
8.8.1 Clutch Assembly – Removing
1. Remove the rear cover(1) and the PTO shaft (2)
from the winch.
2. Unspool the cable off the winch drum. Remove the
end from the cable capture block.
00510
1
2
Fig. 39 – Rear Cover and PTO Shaft
3.
Attach a lifting sling through the inside of the
clutch/drum frame assembly to support it.
4. Remove the three screws (3) on the front side of
the winch securing the drum frame to the main
A-frame.
00508
3X
3
Fig. 40 – Screws on the front side
5. Remove the bolt (4) and locknut (5) from the end of
the drum shaft
00509
4
5
Fig. 41 –
Drum Shaft Bolt
Service and Maintenance
FX40
PTO-driven Log Skidding Winch
34