7.7 Conveyor Axle Position
Tongue weight varies depending on conveyor length.
Axle Location on Wheel Base Frame
The axle is positioned and bolted to the conveyor frame
based on the measurements in the following table. Measure
from the front of the wheel base frame to the center of the
axle (measurement 'X').
Conveyor Model
Measurement 'X'
CT16B
41-½" (105.4 cm)
CT24B
23-½" (60 cm)
NOTE:
CT model shown in the illustration. CT-B model
set-up is the same.
Tongue Weight, Adjusting
Adjust tongue weight further for tow vehicle capability or
preference using the additional holes provided in the conveyor
wheel base frame.
IMPORTANT! If repositioning axles, always install spanner
bar and properly torque-tighten all fasteners.
X
01208
1
2
2
3
Fig. 42 –
Axle Position on Wheel Base Frame
1. Conveyor Tongue
2. Axles
3. Spanner Bar
CT16B / CT24B
Trailer Firewood Conveyor
Operating Instructions
33
Summary of Contents for CT16B
Page 47: ......
Page 48: ...www wallensteinequipment com...
