40
BXTR6438
4.10.1 Prepare for Transport:
4.10 Transporting
Follow these instructions:
1.
Stow feed table and secure the latch.
2.
Insure that the machine is securely attached to the tow
vehicle and the ball coupler hand wheel is snug. Insert
mechanical retainer through the ball hitch.
3.
Always use safety chains crossed underneath the trailer
tongue.
4.
Raise jack stand and secure it to the transport socket on
the side of the trailer.
5.
Connect the light harness cable. Check that all the lights
and reflectors required by the highway authorities are in
place, clean and working.
6.
Check tire air pressure. Check for cuts or damaged rims.
7.
Check lug nuts and re torque if necessary. New chippers
check after 20-25 mi (32-40 km) and regularly check
weekly.
8.
Inspect and replace any axle dust caps that are damaged
or leaking.
9.
Turn the discharge hood and point toward the feed table to
reduce the width of the machine.
10.
Check and secure chipper components including:
• Tool and tank doors latched
• Belt access covers, and shields secured
• Rotor housing secured
• Feed table latched.
11.
Do not allow riders. Do not drink and drive.
12.
Never exceed 50 mph (80 km/h). Slow down when
encountering rough road conditions and cornering.
Chute Turned
Ball Hitch Secured
Jack leg raised
Feed Table Stored
and Latched
Safety Chains
Attached
Light Harness
Connected
