25
BXTR6438
3.6.4 Menus
Main screen
The
Main
screen is the default screen with the ignition
key in the ON position. Pressing the key below
Home
icon in any sub menu takes you back to the
Main screen.
If the display is left unattended for a period
(approximately 60 seconds), the system returns to the
Main screen.
The
Main
screen displays:
•
Feed Position (feed roller rotation direction)
•
Rotor Speed (rpm)
•
Hours (rotor hours of operation)
•
Settings Icon
1. Feed Position
Feed roller drive position is displayed with colored icons to
indicate direction.
REVERSE
REVERSE (red arrows) – feed rollers
are reversing. Material in the rollers is
being pulled back away from the rotor.
NEUTRAL
NEUTRAL (amber) – feed rollers are
stopped.
FORWARD
FORWARD (green arrows) – feed
rollers are going forward. Material in
the rollers is pushed into the rotor.
LOW RPM
LOW RPM (green arrows) – with the
feed control bar in Forward, feed rollers
are not moving because rotor RPM
is too low for chipping. Once engine
speed is increased above the minimum
start speed, FORWARD is displayed.
2. Rotor Speed (rpm)
Displays the speed (revolutions per minute) the rotor is
turning. A value of 0000 indicates the rotor is not turning.
3. Hours
Counts the total operating hours of the rotor. This value
is not resettable. (Engine hours are displayed on the hour
meter beside the ignition key. Use Engine Hours as a
service interval guide.)
4. Settings
Press the soft key button below
Settings
icon to
navigate to the
Settings
screen.
0:00 HOURS
ROTOR SPEED
FEED POSITION
NEUTRAL
RPM
0000
01248
1
2
3
4
Fig. 3 –
Main Screen
