18
BXTR6438
13. Caution!
Risk of serious injury or death if
the engine is not shut off during
maintenance procedures.
Shut off the engine and remove
the key.
IMPORTANT! If parts are replaced that have
safety signs on them, new signs must be applied.
Safety signs must always be replaced if they
become damaged, are removed, or become
illegible.
Safety signs are included in the product decal kit
available from your authorized dealer. Decals are not
available separately.
2.18 Replacing Damaged Safety Signs
•
Always keep safety signs clean and legible.
•
Replace safety signs that are missing or have become
illegible.
•
Parts that were replaced with a safety decal on them must
also have the safety sign replaced.
•
Replacement safety signs are available from your
authorized Distributor, Dealer Parts Department, or
Wallenstein Equipment.
Procedure
1.
Be sure that the installation area is clean and dry.
2.
Be sure temperature is above 50 °F (10 °C).
3.
Determine exact position before removing from the backing
paper.
4.
Pull the decal off the backing sheet, align the sign over
the specified area, then carefully press the exposed sticky
backing in place.
5.
Use a piece of the backing paper to smooth the decal out,
pressing from the center outwards.
6.
Small air pockets can be pierced with a pin and smoothed
out using the piece of sign backing paper.
