Wallenstein BXC34, Operator'S Manual, Page: 25 / 52

BXC34 / BXC34 Bundle
Wood Chipper
Operating Instructions
25
6.4.2 Check the Engine Fuel Level
WARNING!
Keep fuel away from sparks, open flame, pilot
lights, heat, and any other source of ignition.
Fuel and vapors are extremely flammable and
explosive. Fire or explosion can cause severe
burns, bodily harm, or death.
CAUTION!
Check the fuel level outdoors or in an area where
there is good air flow. Fuel vapors are very
toxic. Breathing fuel vapors can cause irritation,
illness, or unconsciousness.
Check the engine fuel level before each use.
Starting work with a full tank helps to eliminate or reduce
operating interruptions for refueling. Avoid running the tank dry.
1. Park the machine on level ground.
2. Stop the machine.
For instructions, see
Stop the Machine on page 27 .
3. Wait a minimum of five minutes for the engine to cool.
4. Turn the fuel cap counterclockwise to remove it.
5. Check the fuel level. The fuel tank is full when the fuel level
is visible 1/2 inch (12 mm) below the filler neck. There
must be room for fuel expansion.
6. Complete one of the following:
-
If there is enough fuel in the tank, install and secure the
fuel cap to prevent spillage.
-
If there is not enough fuel in the tank, add fuel. For
instructions, see
Add Fuel to the Engine.
01778
Fig. 13 –
Fuel cap
6.4.3 Add Fuel to the Engine
WARNING!
Never smoke or vape while working
with fuel. Fuel vapors can explode
causing injury or death. Keep sparks,
fl ames, and hot components away.
W027
CAUTION!
Add fuel to the engine outdoors or in an area
where there is good air flow. Fuel vapors are very
toxic. Breathing fuel vapors can cause irritation,
illness, or unconsciousness.
The engine requires clean, fresh, unleaded gasoline with a pump
octane rating of 87 or higher (research octane number [RON]
of 91 or higher). Gasoline with up to 10% ethanol (gasohol)
is acceptable. For more information, see
Engine Fuel on page
34 .
For information about use at high altitudes, see the engine
manufacturer's manual.
Fuel tank capacity: 0.82 US gal (3.1 L).
1. Stop the machine.
For instructions, see
Stop the Machine on page 27 .
2. Wait a minimum of five minutes for the engine to cool.
3. Turn the fuel cap counterclockwise to remove it.
4. Add the correct type and amount of fuel to the tank until the
fuel level is visible 1/2 inch (12 mm) below the filler neck.
Leave room for expansion.
Do not overfill the tank.
5. Carefully, clean up any spilled fuel. Wait until the fuel dries
before starting the engine.
6. Install and secure the fuel cap to prevent spillage.