Wallenstein BX36S, Operating Manual

Page: 25 / 52

BX36S
3PH Self-feed Chipper
Controls
25
Grip Handle
Latch Handle
Fig. 14 –
Adjusting discharge chute
11.2 Hood Deflector
Model BX36S
The discharge chute is equipped with a hood deflector
on the end of the chute to direct the chips exactly
where desired. The deflector is held in place by
clamping bolts on each side.
1. Loosen the clamping bolts on each side.
2. Move the deflector to desired position and tighten
the manual clamps.
Manual Clamp
Deflector
Fig. 15 – BX36S Hood Deflector
Model BX52S
The discharge chute is equipped with a spring
tensioned hood deflector on the end of the chute to
direct the chips exactly where desired.
1. Lift and push forward the adjustor grip handle and
move the deflector into position as required.
2. Lock the deflector into position by pulling back and
down.
Deflector
Adjuster
Deflector
Fig. 16 – BX52S Hood Deflector
Models BX72S and BX102S
The discharge chute is equipped with a hood deflector
on the end of the chute to direct the chips exactly
where desired. The deflector is held in position by a
slotted position handle.
1. Grasp the handle and lift slightly to clear the
handle cogs
2. Move the deflector with the handle as required
3. Lock the deflector into position by lowering the
handle into one of the slots.
Fig. 17 –
BX72S, BX102S Hood Deflector
Deflector
Deflector
Adjuster