Alpha/Delta (Kinetic Operator) Installation and Maintenance Manual
Revision 1 - MAY 2023
85
USING THE SMARTDC CONTROLLER BUTTONS IN MENU MODE
Using the SmartDC Controller Buttons in Menu Mode
The buttons on the SmartDC Controller let you navigate, change, or clear the information in the display
menus. Refer to Figure 24.
The buttons with text above and below have two functions. Use these buttons to enter operating
commands or navigate through the User and Installer Menus. The singular use of these keys is dependent
on the operator mode.
Three different modes exist:
•
Run Mode - gate is operational awaiting commands. Refer to Using the SmartDC Controller Buttons
in RUN Mode herein.
•
Menu Mode - motor disengages and operator commands are ignored. Data entry, menu navigation,
and menu selection can be accomplished via the Controller buttons or through a S.T.A.R.T. software
connection using the USB port.
•
Fault Mode - alerts, faults or errors appear on the display. Some errors or faults can be reset with
the STOP button while more serious faults require the RESET button or cycling power. Faults indicate
a need for diagnosis and resolution. Refer to
“SmartDC Controller Troubleshooting” on page 151
Figure 24. Function of the SmartDC Controller Buttons in Menu Mode
Summary of Contents for ALPHA
Page 167: ...Figure 47 Schematic for Kinetic DC 15 Kinetic 1 and Kinetic DC 10F Kinetic 2 Operator s...
Page 168: ......
Page 170: ......
Page 180: ......
