5
SERVICE AND MAINTENANCE
MAINTENANCE SAFETY
1. Follow ALL the operating, maintenance and
safety information in the manual.
2. Follow good shop practices:
-
Keep service area clean and dry.
-
Be sure electrical outlets and tools are
properly grounded.
-
Use adequate light for the job at hand.
3 Use only tools, jacks and hoists of sufficient
capacity for the job.
4. Before servicing, adjusting, repairing or
maintaining unit, ensure that unit power
source is completely shut down, and can not
start-up.
5. Lock out tag out master panel before servicing
airlock.
6. Lock out tag out master panel before
performing any maintenance or service work
on machine.
7. Keep hands, feet, hair and clothing away from
all moving and/or rotating parts.
8. Clear the area of bystanders, especially small
children, when carrying out any maintenance
and repairs or making any adjustments.
9. Be sure that all lines and hoses are grounded
when maintenance work is completed.
10. Make sure all guards are in place and
properly secured when maintenance work is
completed.
5.1
SERVICE
5.1.1
FLUIDS AND LUBRICANTS
1.
Grease:
Use an SAE multi-purpose high temperature
grease with extreme pressure (EP) character-
istics. Also acceptable is an SAE multipurpose
lithium based grease.
2.
Blower Oil:
Use Walinga Super Duty Blower oil (Walinga
Part# 98-13813-5) or equivalent.
SIZE
510
614
Front
1.0 liter
(1.1qt)
1.4 liter
(1.5 qt)
Rear
2.0 Liters
(2.1 qts)
2.5 liters
2.6qts)
3.
Storing Lubricants:
Your unit can operate at top efficiency only
if clean lubricants are used. Use clean
containers to handle all lubricants. Store
them in an area protected from dust,
moisture and other contaminants.
5.1.2
GREASING
Refer to Section 5.1.1 for recommended grease.
Use the Service Record checklist provided to keep a
record of all scheduled servicing.
1. Use a hand-held grease gun for all greasing.
1. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
2. Replace and repair broken fittings immediately.
3. If fittings will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
Summary of Contents for ULTRA-VEYOR SYSTEM
