For adjusting the height please open the corresponding locking screws.
Adjust the device to the desired height.
Tighten the locking wheel.
For adjusting the depth please open the corresponding locking screws.
Adjust the device to the desired depth.
Tighten the locking wheel.
In order to mount the device on the tripod and your camera, open the
corresponding locking screw.
Take your tripod or camera and tighten the locking wheel.
WARNING Only mount the device on a tripod that is designed for the
weight and dimensions of the device. See
Technical specifications
.
WARNING Before each use ensure that the camera is mounted safely.
Check all locking screws.
7.
Connect flash to powerpack
A
B
Connecting socket for flash devices
On/off switch
Switch on device.
See
Switch device on and off
.
Unscrew protective caps.
Plug connecting cable of the flash into the connecting socket of the
powerpack.
8.
Switch device on and off
Switch device on:
Set main switch to I (ON).
The display lights up when the adjusted flash output is reached. The READY
indicator lights up.
Switch off device:
Set main switch to 0 (OFF).
All lights go out.
9.
Adjusting the device
9.1.
Adjust flash output
You can adjust the flash output of the flash heads steplessly from 1/1 full
output to 1/8 using the output regulator.
A
B
Sync socket
Output regulator
9.2.
Prepare and adjust flash trigger
Prepare flash trigger by camera
NOTE: Please pay attention to the manual of the camera manufacturer about
flash synchronization.
1.
Plug sync cable into connecting socket for the sync cable on the end of
the device.
2.
Plug other end of the sync cable into the X-socket of your camera.
B
A
A
B
14
15
