220.805.011
20
Date: 2021-12-09
Set up
Warning! Rea
d “Safety Information”
on page
operating, or servicing the Winch 25.
Warning! Before running the winch, it is important to put a counterbalance on the
wire. This is necessary, as the slack detection switch otherwise will be activated
and will stop the winch.
Warning! Only experienced DMX users should operate the winch. Contact Wahlberg
Motion Design for further information and education on DMX protocol.
Counterbalance
When the winch has been mounted, it is important to hook on a counterbalance before
running with it. This can be done by hanging some sort of load at the end of the wire.
The counterbalance is very important, because the winch will not run without it.
Menu setting
Use the push buttons on the display to enter and change menu settings
Use the arrows
&
to go up or down in the menu
Push
to set values.
Push
to go back one level in the menu
Summary of Contents for Winch 25
