220.805.011
17
Date: 2021-12-09
Emergency stop switch (Optional)
Warning! By default the emergency stop is NOT enabled!
The Winch can be configured with an emergency stop; by default the emergency stop
is not enabled.
The DMX control from a lighting desk should always have a set up so there is a button
that sets the speed of the winch in operation to 0%. Normally lighting desks have a
“blackout” button that sets all signals to 0% and this will also cause t
he winch to stop.
If the emergency stop switch is activated the red Error LED will be lit and the screen
display shows
: ‘EMERGENCY STOP PRESSED’
and the current start channel of the unit:
The emergency stop switch is connected to the male 4 pole XLR connector on the
winch. Pin 1 and Pin 4 should be powered with 12-15 volt DC to enable operation of
the winch.
Pin out:
Connection
Pin 1
GND
Pin 2
Not connected
Pin 3
Not connected
Pin 4
12-15 V DV
The emergency stop power supply and plug is available for purchase from Wahlberg Motion
Design.
Summary of Contents for Winch 25
