76 Configuration
WAGO-I/O-SYSTEM
750
758-874/000-131
WAGO-I/O-IPC-C6
Manual
Version 1.0.0
9.1.5
"ETHERNET" Page
Configure the transmission speed and communication method of the I/O-IPC
ETHERNET interface on this page. To accept your entries, click on the
[SUBMIT]
button.
Table 31: Description of the Parameters of the "ETHERNET" Page
Transmission Mode Eth0 und Eth1
Autonegotiation on
When the function is enabled, two ETHERNET interfaces (e.g.
from a computer and I/O-IPC) connected to each other establish
the maximum possible transmission speed and the duplex
method together independently.
Settings
Select the fixed transmission speed and communication method:
10 Bit or 100 Mbit half-duplex
(Half-duplex: Information can be send or received)
10 MBit or 100 Mbit full-duplex
(Full-duplex: Information can be sent and received
simultaneously)
9.1.6
"NTP" Page
On this page, configure the NTP parameters for setting the time clock. To accept
your entries, click on the
[SUBMIT]
button.
Table 32: Description of the Parameters of the "NTP" Page
Configuration Data
Enabled
Disabled
Activate/deactivate time update here.
Port
Here, enter the port number for the NTP access (base setting:
123)
Time Server
Enter the IP address of the time server here.
Update Time (sec)
Set the cycle time here to specify how often the time should be
requested from the time server.