WAGO I/O SYSTEM FIELD 765-2704/200-000, Product Manual

Page: 32 / 42

765-2704/200-000 Diagnostics
32 Product manual | Version: 1.0.0
2AO FLD IOL CONV 0-10V
Table 45: Variables – Parameter Setting Errors
Name Description Subindex Data
Type
Length Factory
Setting Value Range
Parameter set-
ting error Indicates the
parameter that
was set incor-
rectly at the
time of down-
load 0 ArrayT 10*32 bits 0 0 (OK)
786432 (device access
blocks, index 12)
11.2.5 Error Types
Table 46: Process Image – Error Types
Error Code Name Description
32785 d / 0x8011 Index does not exist Access to an index that does not exist
32786 d / 0x8012 Subindex does not exist Access to a subindex that does not exist
32800 d / 0x8020 Service is currently unavailable The parameter cannot be accessed. The product
does not allow this in its current state.
32801 d / 0x8021 Service currently unavailable –
local operating mode The parameter cannot be accessed, since the
product is currently in local operating mode.
32802 d / 0x8022 Service currently unavailable –
product operating mode The parameter cannot be accessed, since the
product is currently in remote operating mode.
32803 d / 0x8023 Access denied Write access to a read-only parameter
32816 d / 0x8030 Parameter value outside valid
range The parameter value that was written is outside
the permissible value range.
32819 d / 0x8033 Parameter length overrun The length of the parameter that was written is
greater than is allowed.
32820 d / 0x8034 Parameter length underrun The length of the parameter that was written is
less than is allowed.
32821 d / 0x8035 Function unavailable The product does not support the command that
was written
32822 d / 0x8036 Function currently unavailable The product does not support the command that
was written in the current state.
32832 d / 0x8040 Invalid parameter set The individual parameter value that was written
collides with the other parameter settings.
32833 d / 0x8041 Inconsistent parameter set Inconsistencies were detected at the end of the
block parameter transfer. The product plausibility
check failed.
32898 d / 0x8082 Application not ready Access was denied because the product is not
currently ready.
11.2.6 Events
Table 47: Process Image – Events
Code Device status Name Type Description
16384 d
0x4000 4 (error) Temperature
error Error Overload
16912 d
0x4210 2 (Outside
specification) Permissible
product tem-
perature ex-
ceeded Warning Locate and eliminate heat source
20480 d
0x5000 4 (error) Hardware fault
in product Error Replace product
25376 d
0x6320 3 (Function
test) Parameter er-
ror Error Check the datasheet and values.