WAGO 852-1328, Product Manual

Page: 56 / 92

852-1328 Configuration in the WBM
56 Product manual | Version: 1.2.0
Industrial Managed Switch
Figure 40: WBM “Diagnostics” Page – “Modbus TCP” Tab
To set a Modbus Address for the industrial managed switch, choose a number from 1 to
247 and enter it in the Modbus Address field. Click
[Submit] button to configure it. To en-
able the Modbus protocol on the industrial managed switch, check the box behind the
Modbus Enable and set a Modbus Port number by choosing a number from 1 to 65535
and enter that number in the Modbus Port field. Click
[Submit] button to set the Modbus
TCP. Table “WBM “Diagnostics” Page – “Modbus TCP” Tab” summarizes the descrip-
tions of the Modbus TCP’s parameters.
Please refer to Appendix for the Modbus Memory mapping (see chapter
8
Modbus-Reg-
ister [
}
86] ).
Table 28: WBM “Diagnostics” Page – “Modbus TCP” Tab
Parameters Factory Default Description
Modbus Address 1 Enter a number from 1 to 247 to set the Modbus Address of the in-
dustrial managed switch.
Modbus Enable Uncheck Enable the Modbus protocol on the industrial managed switch by
checking the Modbus Enable box.
Modbus Port 502 Enter a number from 1 to 65535 to set the Modbus service port
number for the industrial managed switch.
10.5.3 System-Log
10.5.3.1 Setting
The user can enable how the system log (syslog) will be saved and/or delivered to other
system in the System Log Setting tab page as show in Figure” WBM “Diagnostics” Page
– “System Log” – “Setting” Tab”. The syslog can be saved to flash memory inside the in-