852-1328
Configuration in the WBM
Product manual | Version: 1.2.0
41
Industrial Managed Switch
Table 18: WBM "Configuration" tab – "SNTP" page
Parameter
Description
Current Time and Date
Current Time
This field displays the current time when you open or refresh the WBM.
Current Date
This field displays the current date when you open or refresh the WBM.
Time and Date Settings
NTP Server
Choose a predefined time server (public) or enter the IP address of a time server manu-
ally (manual).
Public
Select one of the predefined time servers
Manual
IP/Domain
Select whether you will specify the IP address or fully qualified
domain name for the time server
Manual
In the text field below, enter the IP address or fully qualified domain name for the time
server
Time Zone
Select the time zone you are located in.
Daylight Saving Settings
Enable State
Select Enable to enable Daylight Saving Settings or Disable to disable Daylight Saving
Settings.
Start Day
Enter the date and time for the start of daylight saving time if you have activated this op-
tion. The time is displayed in 24-hour format.
End Day
Enter the date and time for the end of daylight saving time if you have activated this op-
tion. The time is displayed in 24-hour format.
10.4.4 Network Settings
In this tab page, users may modify network settings of Internet Protocol version 4 (IPv4)
for the WAGO industrial managed switch.
The Network Settings tab page is depicted in Figure “WBM “Configuration” Page – “Net-
work Settings” Tab”. Inside the Network Settings box, the user can enable Dynamic Host
Configuration Protocol (DHCP) client inside the switch by checking the DHCP box so that
the switch can obtain IP address’ setting automatically from a DHCP server available on
the user’s local network. If the DHCP is enabled, the rest of the fields will be disabled.
Note that the user should consult your local network administrator for information about
the availability of DHCP server. If the user prefers a static IP setting, then the user can
proceed to enter the IP Address, Subnet Mask, Gateway, and the Primary DNS. If the
user set gateway or DNS on this page, the industrial managed switch will not use the
gateway or the DNS from DHCP server. After entering the desired information, please
click
[Submit]
button to change the IP Setting.
