852-1328
Configuration in the WBM
Product manual | Version: 1.2.0
39
Industrial Managed Switch
• If the switch does not receive an SNTP reply packet, it repeats the challenge every ten
seconds.
• If the switch receives an SNTP reply, it repeats the time request from the NTP server
every hour.
• If the time zone and NTP server changes, the switch repeats the request process.
• There is no default SNTP server.
10.4.3.2 SNTP Setup
A mode must first be selected from the Mode pull-down list. Manual mode disables
SNTP. The time must then be set manually. The Network Time Protocol mode enables
SNTP. Both of these modes are described below.
Mode: Manual
Select Manual mode to disable SNTP. The time must then be set manually.
Figure 26: WBM "Configuration" page – "SNTP" tab
Table 17: WBM "Configuration" page – "SNTP" tab
Parameter
Description
Current Time and Date
Current Time
This field displays the current time when you open or refresh the WBM.
Current Date
This field displays the current date when you open or refresh the WBM.
Time and Date Settings
Date
Select the date in the format day/month/year that you are manually setting for the sys-
tem.
