36 Connect Devices
Compact Power
787-1200 Power supply
Manual
Version 1.0.0
5.1
Connectors
The supply lines are connected on the input or primary sides and on the output or
secondary sides with WAGO's
picoMAX
®
plugable connectors (see Section
“Device Description” > “Connections”):
Table 25: Connectors
Input Side
Output Side
WAGO connectors
picoMAX
®
5.0
picoMAX
®
3.5
Series
2092
2091
Connection
2-pole
“L” and “N”
3-pole
one “+” and two “-”
5.1.1
Connecting Conductors
WAGO's connectors are designed for solid or fine-stranded wires with and
without ferrules.
Connect only one conductor per connector!
You must only connect one conductor to each spring clamp connection. Do not
connect more than one conductor at a single connection!
5.1.1.1 Connecting Using a Tool
You have to use a screwdriver or an operating tool to connect the following
conductors:
•
Fine-stranded conductors without ferrules
•
Fine-stranded conductors with uninsulated ferrule, cross section
≤
0.5 mm²/AWG 22
Proceed as follows:
1.
To open the spring clamp, depress the orange push-button with a tool.
2.
Insert the conductor into the corresponding connection opening.
3.
To close the spring clamp connection, release the push-button. This
secures the conductor.
