60
Parameterizing
WAGO-TO-PASS® 761
761-314 TO-PASS® Mobile, 4 AI
Manual
Version 2.0.0
Pos : 34.18 / Serie 759 ( WAG O-Soft ware)/T O-PASS Konfig urati onssoft ware/ Parametrier ung/ Par ametrierung I /O AI @ 3\ mod_1223559234859_21.doc x @ 23783 @ 3 @ 1
7.5.3
Analog Inputs
Select your
TO-PASS
®
telecontrol module from the left side of the project tree
using the identifier. Select the input to be configured under
Analog Inputs
. The
parameters of the input are given on the right side.
The buttons and input fields are identical for all analog inputs:
Figure 26: Configuring the analog inputs
Table 29: Configuring the analog inputs
Standardization
Input signal
Use these buttons to select the input signal for the sensor
connected to the
TO-PASS
®
telecontrol module.
Min. value
In this field enter the starting value from which the given
value is normalized. This value corresponds to the minimum
input current value of 0 mA or 4 mA.
Max. value
In this field enter the end value up to which the given value is
normalized. This value corresponds to the maximum input
current 20 mA.
Unit
In this field enter the unit with a maximum of 5 characters
with which the normalized process value is to be transmitted.
