WAGO-I/O-SYSTEM 750
Device Description
55
750-880, 750-880/025-000 ETHERNET Programmable Fieldbus Controller
Manual
Version 1.0.1
Only use recommended memory cards!
Use only the SD memory card available from WAGO (item no. 758-879/000-001)
since it is suitable for industrial applications under difficult environmental
conditions and for use in the fieldbus controller.
The compatibility to other storage media available in trade cannot be ensured.
Additional information about the memory card
For technical information about the memory card, see the data sheet for the SD
memory card (item no. 758-879/000-001).
The data sheet is on the Internet at:
Service
Documentation
WAGO-I/O-SYSTEM 758
1
SD
SD
SD
SD/SDHC
Card
2
Figure 28: Opening the memory card slot, inserting the SD card
4.4.4.1
Inserting a Memory Card
1.
Use an activation tool or a screwdriver to open the transparent cover flap by
folding it upwards.
2.
Hold the memory card so that the contacts are visible on the left side and the
sloping edge is towards the bottom, as depicted in the figure above.
3.
Insert the memory card into the slot of the fieldbus controller.
4.
Push the memory card all the way in. When you let go, the memory card
will move back a little and then snap in.
5.
Push the cover flap back in by folding it downwards until it snaps in.
