WAGO I/O SYSTEM 750 XTR
Mounting 85
750-8202/040-001 PFC200 2ETH RS TELE XTR
Manual
Version 1.2.0, valid from FW Version 03.01.07(13)
5.3.2
WAGO DIN Rail
WAGO carrier rails meet the electrical and mechanical requirements shown in the
table below.
Table 39: WAGO DIN Rail
Order number
Description
210-112 /-113
35 × 7.5;
1 mm; steel blue chromated; slotted/unslotted
210-197 /-114
35 × 15; 1.5 mm; steel blue chromated; slotted/unslotted
210-118
35 × 15; 2.3 mm; steel blue chromated; unslotted
210-198
35 × 15; 2.3 mm; copper; unslotted
210-196
35 × 8.2; 1.6 mm; aluminum; unslotted
For vibration loads > 4g, observe the following installation instructions:
•
Use pan-head screws or blind rivets at least every 60 mm (12 mm pin
spacing) to secure the DIN rail.
•
Make the open conductor length between strain relief and wire connection
as short as possible.
•
Use the reinforced end stop 249-197.
•
When using the PFC200 750-8202/040-00x, carrier rails without an oblong
hole must also be used. Alternatively, a material thickness of min. 1.5 mm
must be maintained.
•
When using the PFC200 750-8206/040-00x or 750-821x/040-010, carrier
rails without an oblong hole with a material thickness of min. 2.3 mm must
also be used.
Table 40: Permissible WAGO Carrier Rails When Using XTR PFC200
Item
Number 750-8202/040-00x 750-8206/040-00x 750-821x/040-010
210-113
×
–
–
210-114
×
–
–
210-197
×
–
–
210-118
×
×
×
