WAGO-I/O-SYSTEM 750 XTR
Commissioning 219
750-495/040-00x 3-Phase Power Measurement Module 690 V
Manual
Version 1.2.0
8.4.3
“Energy” Tab
On the “Energy” tab, you can adjust or reset the energy values for each phase
after entering the password.
The initial password is “wago.“ After the first use, please change this password
using [
Change password
].
If you have forgotten the password, you can uninstall and reinstall the plug-in for
the 3-Phase Power Measurement Module. This resets the password to the initial
password.
•
The I/O module counts the
Energy consumption
and saves the values
cyclically. However, with the [
Save
] and [
Delete
] commands, you can save
the energy consumption prematurely or reset it to 0.
•
You can also set the
Power meters
for total active energy and total
reactive energy to a particular value, i.e. pre-populate them, by selecting
the meter in question, entering a value in milliwatt hours and clicking
[
Save
]. After this is set, the energy metering starts from this value setting.
These actions are performed immediately and cannot be reverted. Therefore, the
[
Save
] button at the bottom of the window is disabled.
Figure 76: “Energy” Tab
