212 Commissioning
WAGO-I/O-SYSTEM 750 XTR
750-495/040-00x 3-Phase Power Measurement Module 690 V
Manual
Version 1.2.0
8.3.6.7 “Measurement Recording” View
The “Measurement Recording” view shows the progression over time of
3 measured quantities. Select the measured quantities to display from the
corresponding selection list.
Figure 71: Measured Values – Measurement Recording
As a general rule, you can select from the following options in the three charts:
• The samples are displayed for a specific duration (with )
• A specific number of samples is displayed (with ).
You can then specify the duration through the start and end time or enter the
number of samples. Furthermore, you can select the measurement interval, i.e.
the sample rate, from 250 to 300,000 ms in both cases.
When the arrow is clicked, the three [
Start
] buttons generate a drop-down list
from which you can specify that no export CSV file is generated with “No Export.”
Normally when you click [
Start
], a Save window opens in which you can specify
the storage location for the CSV file. Measurement begins after you do this. Use
[
Stop
] to stop the measurement prematurely. For examples of CSV files, see
section “Appendix.”
Default storage location for measured values in earlier software versions
With software versions below 1.8.5.556, you can also set a default storage
location for the measured value in the “Settings” dialog via the “Application” tab
