2789-9023
Commissioning
50
Product manual | Version: 1.0.0
EtherNet/IP Communication Module
Figure 10: Module Settings > System
Setting the Default IP Address with the Reset Button
Note
If you no longer have the IP address of the module, you can reset the network settings
with the reset button on the module.
1. Hold the reset button down for eight seconds until the “COM OK” LED lights up
briefly.
2. Release the reset button.
ð
The product reboots, and the following network settings are made:
Configuration type
: static IP address
IP address
: 192.168.1.17
Gateway address
: 192.168.1.1
Setting the IP Address via Modbus Command
•
Write to the corresponding addresses using Modbus FC10 Internal Module Parame-
ters.
