WAGO 2789-9023, Manual

Page: 33 / 94

2789-9023 Fieldbus Description
Product manual | Version: 1.0.0 33
EtherNet/IP Communication Module
General Device Parameters
Table 30: General Device Parameters – Modbus
Attribute ID Access Data type Description
122 Get/Set UINT16 Device address
124 Get/Set UINT32 Baud rate
This parameter can be used to set the baud rate. The op-
tions are as follows:
Value Baud Rate
4800 4800 baud
9600 9600 baud
19200 19200 baud
38400 38400 baud
57600 57600 baud
115200 115200 baud
230400 230400 baud
560800 560800 baud
126 Get/Set UINT16 Data bits
The options are as follows:
Value Data Bit
0 7
1 8
127 Get/Set UINT16 Stop bits
The options are as follows:
Value Stop Bit
0 1
1 0.5
2 2.5
3 1.5
128 Get/Set UINT16 Parity
The options are as follows:
Value Parity
0 None
1 Even
2 Odd
129 Get/Set UINT16 Response delay (unit: ms)
130 Get/Set UINT16 Data format
The options are as follows:
Value Data Format
0 Big-endian (B0, B1, B2, B3)
1 Middle-endian (B2, B3, B0,
B1)
2 Little-endian (B3, B2, B1,
B0)
4.2.7.2 Device Parameters of the WAGO Pro 2 Power Supply
The following parameters of the WAGO Pro 2 Power Supply can be edited via the prod-
uct.