Working with the spray guns
05 / 2009
0351701
- PEA-T3XL
15
3.3
Performing a color change
During a color change all parts carrying powder in the entire coating system
must
be
thoroughly
cleaned of powder residue. In the following only the procedure for the powder
spray gun is described.
•
Flush the gun manually and remove all powder residues.
•
Switch off the powder feed and secure against inadvertent switching on.
P_00744
A
2
3
4
B
6
7
9
8
5
•
Disconnect the hose for powder feed
7
from the spray gun
6
and place it on the powder
hose take-up
8
.
•
Blow the spray gun out with compressed air.
•
Pull the deflector cone
A
off the charging body
4
.
•
Unscrew the outer nut
2
from the spray gun housing
B
.
•
Carefully pull the nozzle body
3
and the charging body
4
out of the powder tube
5
.
Caution
When pulling out and inserting the parts, ensure that the charging body is not
damaged!
•
Remove powder residue from the parts removed and the spray gun.
•
Carefully refit the charging body 4 and the nozzle body 3 in the spray gun housing B and
tighten using the outer nut
2
.
•
Slide the deflector cone
A
back over the charging body
4
.
•
Take the hose
9
for the new color from hose take-up
8
and connect it to the spray gun
B
.
The spray gun is ready for use again.
