GB
12
Winter storage
In winter, with temperatures under 5°C, keep your Solar Fountain Set in a dry frost-free
place.
MAINTENANCE in the case of a drop in performance
1. Cleaning of the two filter mats (Fig. A, 12
)
●
Disconnect the pump from the solar station (remove plug).
●
Dismantle the base from the filter holder (snap connector).
●
Dismantle the filter holder from the top of the pump (snap connector). For this, use
a screwdriver, for example, to prise the snap connector open.
●
Remove the filter mats from the filter holder.
●
Rinse the filter mats under running water, if necessary fit new filter mats.
●
Remove the jets from the jet base and clean the jet openings of dirt e.g. with the aid
of a toothpick.
☞
For assembly, proceed in reverse order.
2. Cleaning the pump impeller
●
Disconnect the pump from the solar station ( remove plug).
●
Dismantle the base from the filter holder (snap connector).
●
Dismantle the filter holder from the top of the pump (snap connector). For this, use
a screwdriver, for example, to prise the snap connector open.
●
Press the snap connector together with your fingers and remove the suction lid.
●
Extract the impeller with the aid of small flat pliers.
ATTENTION! Do not tilt; do not use hard / sharp tools!
●
Clean the impeller, impeller spindle and pump interior with a suitable brush.
ATTENTION!
Do not tilt; do not use hard / sharp tools!
●
Place the impeller on the spindle again. If the impeller bearing is badly, fit a new
impeller (contact supplier)
Note:
A defective impeller bearing is recognisable by a drop in pump performance
and running noises.
For assembly, proceed in reverse order.
REMOVING / REPLACING BATTERY
ATTENTION!
When removing / replacing the battery, the selection switch must
be set to position “0”!
Use only original WAGNER batteries.
Avoid shorting the battery wires. When replacing spare parts or
batteries, be careful of sharp edges which can cause injury or
which can damage the cables.
Do not pull on the cable of the solar module
.
HAWAII
