Waeco CoolAir CA-800-Mercedes-2, Installation Manual

Page: 30 / 148

Installation CoolAir
30
6.2.7 Attach the cover frame
Tighten the screws carefully so that the cover frame is not damaged.
➤
Fasten the cover frame (see fig. 5 on page 4, 4) to the cab roof using
the spacer sleeves (3) and the original screws (5). The spacer sleeves
keep the cover frame apart from the cab roof.
6.3 Configuration of system software
Before you first start up the system, adapt the controls according to the in-
stallation conditions. This must be done by the person installing the sys-
tem.
In configuration mode, the following system software parameters must be
set on the control panel (see fig. 7 on page 5):
The configuration mode can also be called if the undervoltage protection
has switched off the system and there is only residual voltage.
6.3.1 Start and end configuration mode
The adjustable parameters can be altered in edit mode:
➤
With the system switched off, press the ON/OFF button (see fig. 7 on
page 5, Pos. 1) and hold it down for 2-4 seconds.
➤
Additionally press the operating mode button (see fig. 7 on page 5,
Pos. 4) within these 2-4 seconds.
➤
Let go of the ON/OFF button.
➤
Hold the operating mode button pressed until the LED compressor
flashes.
✓
You are now in configuration mode.
Menu
level
Parameter Meaning
Default
setting
1 Set temperature The system starts with the tempe-
rature defined here.
20 °C
2 Low-voltage
cut-off The battery monitor switches the
system off at the defined voltage. ID number
4 = 23.5
Volt
3 Operating mode The system starts with the opera-
ting mode defined here.
0 =
Automatic
mode
4 Default
settings The parameters 1-3 can be retur-
ned to the default settings. --
CA-800-Install.book Seite 30 Mittwoch, 20. Februar 2008 12:28 12