Waeco ASC 6300 G LE, Operating Manual, Page: 13 / 254

EN
9.
Press
STOP
.
The volume chosen is active and the standby menu is displayed.
12.6 Entering the company data
The company data is printed out with every service log.
1.
In the basic menu use the cursor keys or to select
Other selections
.
Short selection
Free selection
Other selections
ENTER-OK
2. Press ENTER to confirm.
3.
Use the cursor key to select
Service
.
4. Press ENTER to confirm.
5. Enter the password
3282
.
The company data is shown in the third line of the display.
You can enter five lines, each with up to 20 characters.
The display shows the number of lines of company data after the message
Enter company data
(01 to 05).
Use the cursor keys or to select the line of company data you want.
6. Use the keypad and the cursor keys to enter the data. To switch between upper and lower case, press the
key. To delete a character, briefly press the C key. To delete the current line, press and hold down the C
key.
7. Press ENTER to confirm.
8. Press STOP .
The set data is activated.
9. Press STOP again.
The standby menu is displayed.
12.7 Entering the date and time
Date and time are required for logging of the service procedures. The date and the time are printed along with the
company data on every service log.
1.
In the basic menu use the cursor keys or to select
Other selections
.
Short selection
Free selection
Other selections
ENTER-OK
2. Press ENTER to confirm.
3.
Use the cursor key to select
Service
.
4. Press ENTER to confirm.
5. Enter the password
8463
.
6. Use the keypad and the cursor keys to enter the information.
7. Press ENTER to confirm.
8. Press STOP .
The standby menu is displayed.
12.8 Editing default values
The A/C service unit has preset values for the most important service tasks. The default values appear
automatically when you select the respective menu.
You can alter the following default values if necessary:
13