10
11
·
The cutting machine is equipped
with an adjustable conical lever that
changes the height of your cut.
·
When the lever is in the highest
position, the blades will give the
tightest cut.
·
Pushing the lever down gradually
increases the cutting length.
Conical lever
Blade maintenance:
·
To keep your clipper in
top condition, the blades
should be oiled every few
haircuts.
·
For proper oiling, the
unit must be held so
that the blades are in
a downward position.
With the machine blade
in operation, pour 2 or 3
drops of oil on the
upper blade.
Cleaning and maintenance
·
The blades are greased and aligned before leaving
the factory.
·
They should be realigned if they have been removed
for cleaning or replacement.
·
To realign the blades, simply match the teeth of the
upper and lower blades, point for point. The end of the
upper blade teeth should be approximately 0.5 to 1 mm
behind the lower blade. Compare the blades of your
cutting machine with the drawing.
·
If the blade alignment is incorrect, add a few drops of
oil to the blade, switch on the cutting machine for a
few moments, switch it off and unplug it. Loosen the
screws slightly and adjust the alignment. Tighten the
screws after the blade is aligned.
Blade alignment:
Cleaning of the blades:
·
Clean the blades
with the cleaning
brush provided.