Page 48
MACINTOSH-SPECIFIC PROBLEMS
When the pen tip contacts the
tablet surface, the cursor
jumps to the top left corner of
the screen, or the error
message, “Unable to
implement function”, appears
within the PenPartner control
panel.
You may have had another manufacturer’s tablet, and the drivers are
still loaded on your system:
ACECAT: Edit your SYSTEM.INI. Go to the drivers=line in the [boot]
section and remove awintab. Then go to the [drivers] section and
remove the awintab=awintab.drv line. Look also for any reference to
Virtual Tablet and remove it. Save the changes and restart Windows.
KURTA: Edit your SYSTEM.INI by looking for any references to
wtkurta and removing them. Save the changes and restart Windows.
PenPartner only works in
mouse mode and pressure
does not function.
If you are using an iMac, install the iMac Update 1.1 located on the
PenPartner CD-ROM. Then install the PenPartner software.
For any Macintosh, if the PenPartner software was not installed or did
not load properly, the tablet will function in mouse emulation mode
and pressure support will not be available. If the driver failed to load,
see
. If it was not installed, double-click
on the Install PenPartner icon (located on the PenPartner CD-ROM),
and complete the software installation.
