Page 44
USING THE LENS CURSOR
The Intuos Lens Cursor is an ergonomic input device that allows you to enter precise coordinate position
information into your computer. The Lens Cursor reports the position of the cross-hair to the computer.
This makes the Lens Cursor especially useful for tracing and digitizing drawings into graphics and CAD
applications. By default, the Lens Cursor is set to M
OUSE
M
ODE
, which means you can position the screen
cursor like you do with a regular mouse. When using the Lens Cursor to digitize a drawing, the Lens
Cursor must be set to P
EN
M
ODE
.
Refer to
Customizing the 4D Mouse and Lens Cursor
for information on programming the Lens Cursor
buttons.
Click Button
Double-Click Button
Simulates a C
TRL
+
CLICK
by default.
Rotate lens for best viewing angle.
Rear Buttons are ignored by default.
Important: When the Lens Cursor
is not in use, place it on your desk.
Leaving an Intuos tool on the
tablet may interfere with screen
cursor positioning when using
other pointing devices.
