Wacker Neuson LTV 4L, Operator'S Manual

Page: 62 / 106

Operation
7.7 Before Starting
62
Operator’s Manual | LTV 4L/6L | 5100065071 | 02/2023 | [en-US]
7.7 Before Starting
CAUTION
Personal injury or equipment damage hazard
Improper machine setup may cause injury or equipment damage.
► Perform all pre-start checks listed below. Do not operate the machine
until all items on the checklist have been addressed.
Before putting the light tower into service, review each item on the following
checklist. Light towers often run unattended for long periods of time. There-
fore, it is important to make sure that the machine is set up properly to avoid
possible operating problems.
Check machine condition
• Verify that the machine is level and positioned on a stable surface.
• Perform a walk-around to check for visible damage.
• Inspect the lights and lamps: ensure that glass is not broken or cracked.
• Ensure that all electrical connections are tight.
• Verify that all electrical cords are in serviceable condition with no ex-
posed wires, cuts, or cracks in the insulation.
• Close and secure access covers before starting the machine.
Check the engine
• Check fuel, engine oil, and coolant levels. Add fluids if necessary.
• Verify that the fuel lines are undamaged and correctly connected.
• Verify that the air filter element is clean and undamaged. Replace if nec-
essary.
• Check to make sure no debris has lodged in vents, near the radiator, or
around the fan.
• Check to make sure that the exhaust compartment is clean and nothing
is touching the muffler or exhaust pipes.
• Check fan belt and hoses on engine for loose connections or fraying.
Tighten or replace as required.
Review safety information
Review and follow instructions provided in the “Safety” chapter at the begin-
ning of this operator’s manual. For further information,
see Safety on page
12 .