Operation
LB 1
wc_tx000741gb.fm
10
2.2
Setting up the Balloon
Prerequisites
Balloon
Light fixture with bulb
Procedure
Follow the procedure below to set up the balloon.
1. Remove the light from the transport cylinder.
2. Remove the light from the transport bag.
3. Hold the black handle with one hand and pull the stop bolt
(a)
with the other
hand while slowly pushing the handle downward
(b)
. Push forcefully during the
last 5 mm (0.20 in.), as the seals provide some resistance.
The balloon is fully expanded when the stop bolt clicks into the lowest tension posi-
tion.
4. Check that the hook and loop (Velcro) seal is closed all around and that the
white, translucent lower balloon cover shows no signs of serious damage. If the
translucent lower cover is damaged, repair or replace it.
The balloon is now ready to be assembled to the tripod.
WARNING
Electric shock hazard. Electric shock can cause serious injury or death.
f
Never connect the light to its power source and never turn it on until it has been
fully unpacked and assembled to the tripod!