Wacker Neuson EZ38, Operator'S Manual

Page: 84 / 254

4-36
OM EZ38 us 1.1 * ez38i400.fm
4
4.3 Indicator lights and warning lights (overview)
Display element
The display element provides information on the operating state.
and defects.
Information
After switching on starter, the indicator lights are checked during the first 2
seconds. During this time the current reading of the maintenance meter is
displayed. Then the service hours are automatically displayed.
Symbol Designation
High speed (2nd speed)
The indicator light (green) illuminates if high speed is enabled.
Charge indicator light
This indicator light (red) illuminates if the electrical system has a mal-
function. The battery is no longer or insufficiently charged.
Note: This indicator light also illuminates if the starting key is turned to
position 2. The indicator light goes out after the engine is started.
Increase engine speed if the indicator light illuminates. The electrical
system works if the indicator light of the electrical system goes out within
one minute.
Engine oil pressure
The indicator light (red) illuminates and the buzzer sounds.
• Stop the engine immediately and check the oil level.
• If the engine oil level is correct, contact a Wacker Neuson service
center.
Note: The indicator light illuminates when the starter is turned on and
goes out as soon as the engine runs.
At low temperatures, the indicator light can illuminate a few seconds after
the engine is started.
Preheating
The indicator light (yellow) illuminates if the starting key is in position 2.
The indicator light goes out after 4 seconds and the engine can be
started. (Air is preheated.)
Contact a Wacker Neuson service center if the indicator light does not go
out.
Safe load indicator light
The safe load indicator gives the operator optical (red) and acoustic
warnings when the values of the stability table are reached or exceeded.
• Reduce reach or the lift load until both the acoustic signal and the
indicator light in the display element go out.