Wacker Neuson EZ38, Operator'S Manual

Page: 154 / 254

5-58
OM EZ38 us 1.1 * ez38b510.fm
5
Putting the machine back into operation
Information
If the machine was decommissioned over a longer period of time without
performing the specified steps, contact a Wacker Neuson service center
before putting the machine back into operation.
1. Remove anticorrosion agents from bare metal parts.
2. Charge, install and connect the battery.
3. Open the air-intake openings of the air filter system and exhaust pipe.
4. Check the condition of the air filter elements and replace the elements
if necessary.
5. Check the dust valve.
6. Set the fuel cock to
ON .
7. Turn the starting key to position 1 for 2 minutes to supply the engine
with fuel.
8. Check the machine for leaks.
9. Lubricate the machine according to the lubrication plan.
10.Check all engine/machine fluids in the units or tanks, and add fluids if
necessary.
11.If the machine was out of service for over 6 months, change the oil in
the gearbox, engine, hydraulic oil reservoir and other units.
12.Replace the hydraulic oil filters (return and breather filters) if the
machine was out of service for over 6 months.
13.Remove and keep the starting key and fuse F3 in a safe place.
14.Insert the starting key and make the engine turn 15 seconds.
15.Wait 15 seconds.
16.Make the engine turn another 15 seconds.
17.Remove the starting key and put fuse
F3 back in.
18.Start the engine.
19.Let the engine run at idling speed at least 15 minutes without load.
20.Stop the engine.
21.Check the oil levels in all units and add oil if necessary.
22.Check the machine for leaks.
23.Start the machine and ensure that all functions and warning systems
work correctly.
Avoid operation at maximum engine speed or load for more than an hour.