Wacker Neuson DV60, Operator'S Manual

Page: 115 / 212

BA D24 en/us* 1.0 * D24_1_0_500.fm
5-7
Operation 5
Activate road mode
Switch A is located on the switch panel on the right.
Starting machine travel
Starting machine travel (work mode)
1. Start the engine
– see chapter “ Starting the engine” on page 4-39
2. Press the service brake.
3. Move the forward-reverse control into the neutral position.
4. Release the parking brake.
5. Activate work mode
➥
The operating mode symbol appears.
➥
The work hydraulics are enabled.
6. Move the forward-reverse control to the required position.
7. Release the service brake.
8. Press accelerator pedal slowly.
➥
Machine travel starts.
Starting machine travel (road travel mode)
1. Start the engine
– see chapter “ Starting the engine” on page 4-39
2. Lower the skip.
3. If the machine is equipped with a swivel skip, ensure that it is in the
middle position.
4. Press the service brake.
5. Move the forward-reverse control into the neutral position.
6. Release the parking brake.
7. Activate road mode.
➥
The road-travel mode symbol appears.
➥
The work hydraulics are disabled.
8. Move the forward-reverse control to the required position.
9. Release the service brake.
10.Press accelerator pedal slowly.
➥
Machine travel starts.
Stopping
1. Do not actuate the accelerator pedal any more.
➥
The travel speed decreases very slowly until standstill.
2. Press the service brake.
➥
The machine stops.
Fig. 106
Fig. 106 Symbolic photo
1
A
2
Function Position
Activate road mode Set switch A to position 1
Enable work mode Press switch A into position 2