Wacker Neuson DV60, Operator'S Manual

Page: 99 / 212

BA D24 en/us* 1.0 * D24_1_0_400.fm
4-37
Putting into operation 4
Putting into operation for the first time and running-in period
Before putting the vehicle into operation for the first time, check whether
the equipment supplied with the vehicle is complete.
• Check the fluid levels according to chapter “
Maintenance ”.
Each vehicle is correctly adjusted and checked before it is delivered.
Handle the vehicle carefully during its first 50 operating hours.
• Do not load a cold engine.
• Warm up the vehicle at low engine speed and little load, do not warm it
up at a standstill.
• Do not change engine speed abruptly.
• Avoid using the vehicle under heavy loads or at high speeds.
• Avoid abrupt acceleration, braking and changing travel direction.
• Do not run the engine at high speed for extended periods.
• Observe the maintenance plans
– see chapter “7.2 Maintenance
overview” on page 7-2
.
Road traffic regulation accessories
Information
Observe the national and regional regulations during machine travel on
public roads.
Scope of delivery of option Equipment for Austrian road traffic
regulations StVZO :
• Headlights and rear lights
• Turn indicators and clearance lights
• Rotating beacon
• Horn on steering-column lever
• Outside rearview mirrors on left and right
• Numberplate bracket and lights
• Wheel chock
Vehicle travel on public roads
1. Ensure that all legal requirements for machine travel on public roads
are fulfilled. This applies both to the machine and to the operator (for
example a corresponding driving license).
2. Lower the skip completely. If the machine is equipped with a swivel
skip, ensure in addition that the skip is in the middle position.
3. Activate road mode
– see "Activate road mode" on page 5-7
.
Fig. 90