Wacker Neuson DT10, Operator'S Manual

Page: 71 / 120

BA DT10 en - Edition 1.5 * dt10b510.fm
5-9
Maintenance
Stationary fuel pumps
General
Only refuel from stationary fuel pumps. Fuel from barrels or cans is usually dirty.
Even the smallest particles of dirt can cause:
• Increased engine wear
• Malfunctions in the fuel system and
• Reduced effectiveness of the fuel filters.
Refueling from barrels
If refueling from barrels is unavoidable, please note the following (see Fig. 73):
• Barrels must neither be rolled nor tilted before refueling
• Protect the suction pipe opening of the barrel pump with a fine-mesh screen
• Immerse it down to a max. 15 cm above the floor of the barrel
• Only fill the tank using refueling aids (funnels or filler pipes) with integral micro-filter
• Keep all refueling containers clean at all times.
Diesel fuel specification
Use only high-grade fuels
Incorrect
Correct
Fig. 73: Refuelling from a barrel
Grade
Cetane
number
Usage:
• No. 2-D according to DIN
51601
Min. 45
− 15 °C to 45 °C
• No. 1-D according to DIN
51601
For outside temperatures below 4 °C or for
operation above 1500 m altitude