Wacker Neuson DT10, Operator'S Manual

Page: 36 / 120

3-6
BA DT10 en - Edition 1.5 * * dt10b320.fm
Operation
3. 5 Putting into operation
Safety instructions
• Use the foothold to get onto or off the machine
• Never use the controls or movable lines and cables as handholds.
• Never get on a moving machine. Never jump off the machine
Putting into operation for the first time
Important information
• The vehicle may only be put into operation by authorized personnel
– see chapter Selection and qualification of personnel, basic responsibilities on
page 2-4 and the "
" in this operator's manual
– see chapter 2 Safety instructions on page 2-1
• The personnel must have read and understood this Operator’s Manual before putting
the machine into operation.
• The machine may only be operated in technically perfect condition in accordance with
its designated use and the instructions set forth in the Operator’s Manual, and only by
persons who are fully aware of the risks involved in operating the machine.
• Go through the “Start-up” checklist in the following chapter.
Running-in period
Handle the machine carefully during its first 50 operating hours.
The future performance and service life of the machine are heavily dependent on the
observance of the following recommendations during the running-in period.
• Do not overload the machine, but at the same time do not drive too cautiously either, as
the machine will never reach its proper operating temperature.
• Do not allow the engine to run for a long period at maximum speed.
• Increase the load gradually while varying the engine speed
• Strictly observe the maintenance plans in the schedule.
– see chapter 5.10 Maintenance plan DT10 on page 5-37